- 20220819 073739 resized
just another shot. - 20220819 073611 resized
trying to show the gap between the distribution panel and the mppt controller - 20220819 073600 resized
the ac/dc distribution panel in place. - 20220818 151447 resized
the tubes that will go between the boxes - 20220818 151407 resized
running the dehumidifier in the paint room makes the room warm and dry. Like 80 and 40-50% rh. Paint cures well in here. Like it's baked - 20220818 151330 resized
loose fit of RV distribution panel in the frame I mentioned - 20220818 151209 resized
the cover for the switch box is just 1/2" thick Azek painted in Rustoleum gray - 20220806 161502 resized
Swiss cheese. I have black 3" diameter soffit vent covers for the larger holes. the smaller holes will have pipes, conduit or gantry rubber grommets that keep water out. - 20220806 161452 resized
epoxying the edges that will contact the electric panel wall. so it won't suck up water and rot. - 20220806 120844 resized
the ac/dc distribution panel will go over the mppt charge controller. - 20220806 115441 resized
the inverter box is tight., but the vent holes are cut strategically for venting the heat - 20220806 115406 resized
inside view of the pipe cutouts. the pipes will be trimmed to be flush. but I cut things long for the photo, will trim later. - 20220806 115400 resized
using pvc pipe to route the wires between the boxes. the open space in the middle is for bikes, and my rear tire will be up against that wall. so with the wheel shape, the pipes won't block the rear bike wheel shape at all. - 20220806 114731 resized
gantries for the lines that will go to the alternator or chassis ground - 20220806 114727 resized
side view of the switch box